Schlüter® Showerprofile-SA Sloped (Brushed Stainless Steel V4A) H1=6mm
Schlüter®-SHOWERPROFILE-S is a two part profile with a tapered edge, designed to cover adjoining tile edges that become exposed as the shower floor slopes to accommodate drainage to the Schluter®- KERDI-LINE. The tapered profile features a visible surface of brushed stainless steel and a fleece fabric on the reverse for bonding with the tile adhesive. It is designed to be inserted into the U shaped groove of the matching hard PVC support profile. The profile can be used for lateral transitions to the wall or the adjoining floor.
The PVC support profile is available in 6 different thicknesses from 3 mm to 22 mm to match the thickness of the tiles installed in the floor of the shower. The tapered profile is available in longer sections of 120 and 200 cm, with a height of 6 mm or 10 mm at the narrow end. It features a slope of 2% (i.e. the height changes by 2 mm across every 10 cm of length). The profile is simply cut to the required height and length at the narrow and broad ends.
In addition, the height can be further adjusted by inserting the profile into the U shaped support section to various depths.
Notes reference H2 Height
Profile Length 120cm (1.2Metres): H2 =30mm
Profile Length 160cm (1.6Metres): H2 =38mm
Profile Length 200cm: (2 Metres): H2 =30mm
Tapered profiles with higher support profiles are available upon request for greater tile thicknesses. (Bottom image refers)