A water-based impregnating sealer that dries to leave the surface protected and virtually unchanged in appearance. Allows surface to breathe. High quality active ingredients help to protect against staining.
Environmentally friendly
Provides minimal change to the appearance
Helps to reduce efflorescence
Coverage Approx per litre per coat: Lower porosity surfaces 15m² Higher porosity surfaces 7.5m² Polished surfaces 30m²
Water based Impregnating sealer that dries to leave the surface of natural stone and concrete protected and virtually unchanged in appearance.
For use on all types of natural and artificial stone, quarry, brick, concrete & paving. Honed, rough cut, flamed and brushed stone surfaces.
The high-quality active ingredients help to protect against staining. Strongly repels water, dirt, oil, and grease.
When cured surfaces remain breathable. Helps reduce efflorescence.
Preparation: Ensure surface to be treated is completely clean, dry, and free from dirt, grime, cement, and grout. First wash surfaces with a dilute solution of EcoProTec Intensive Cleaner 1: 5 and scrub with a nylon scrubbing pad or deck brush. Rinse well with water and a hose to remove any released residues and leave to dry (24hrs).
Application: Shake bottle before use. Apply evenly using foam roller, paint brush or light pressure sprayer. On more absorbent surfaces apply further coats at hourly intervals until the surface is fully saturated.
On vertical surfaces always apply from the bottom up and wipe up any drips if they occur.
Do not use when surfaces are very cold or very hot. Ideally between 5 - 25°C.
Always test on a small area before general application to help establish best method and optimum number of coats required.