Schluter BARA-RT Connector (Select Height and Colour)
Schlüter®-BARA-RT V is a connector piece for BARA RT profiles and extenal corner pieces.
H = Height for tile covering in mm
H1 = Depth of covering drop in mm
As low as £2.17
Availability: In stock
**Please Note (Colour Availability): Heights 9/60mm to 12/65 are available in BW, GM, HB, PG, RB, and SB Colours. Heights 20/50mm to 30/35mm are available only in GM and PG. ** Schlüter®-BARA-RT is a T shaped connector profile for balcony and terrace coverings. It can be used in conjunction with loose gravel, stilted constructions, or in bonded assemblies. In installations with self-supporting pavers on screed contact points or gravel/crushed stone beds, the trapezoid perforated anchoring leg of Schlüter®-BARA-RT is placed at the edge of the construction on top of the drainage membrane Schlüter®-TROBA or Schlüter®-TROBA-PLUS, where it is aligned vertically and horizontally. The vertical Finishing leg provides a neat Finishing edge for the complete assembly and allows for the drainage of water. The different profile heights from 9 to 65 mm accommodate a variety of edge Formats. The profile can also be used in conjunction with Tile coverings. In this case, the trapezoid perforated anchoring leg of the Finishing profile Schlüter®-BARA-RT is fully embedded in the Tile Adhesive and integrated into the bonded waterproofing assembly. Alternatively, the trapezoid perforated anchoring leg of Schlüter®-BARA-RT can be fully embedded in the screed, which allows for installing the mortar bed flush with the upper edge of the profile. Schlüter®-TROBA-PLUS must be installed as an area drainage membrane between the waterproofing layer and the screed to ensure that water cannot accumulate in the screed layer. If Schlüter®- DITRA 25 is to be installed, the screed must be 3 mm lower than the upper profile edge. The profile creates a neat edge Finish and covers the edge of Tiles as well as any exposed screed.
Write Your Own Review
We found other products you might like!